Operation Manual

Install the wick to the wick sleeve according to the allo-

wed direction engraved on the wick sleeve.

Install the wick sleeve (with wick) to the primary air

tube. And then install the top of the stem into the

groove of the wick sleeve (with wick) from right side,

and left the stem to the end.

nstall the bracket. Then tighten the screw which is hol-

ding the stem.

Put the wick holder and the wick mechanism back into

position.

Screw the four wing nuts hand tight.

Place the knurled wick adjustment knob on the wick

mechanism. Turn the knob as far to the right as possi-

ble. Press the tip-over switch. Check that the wick can

be lowered completely. Repeat this check a number of

times. If the wick cannot be lowered completely it has

not been placed correctly. If this is the case, repeat the

procedure from No. 6.

Put the cabinet back into position and tighten the three

screws. Put the knurled wick adjustment knob back into

position. Now put the combustion chamber back into

position. Check that it is level by sliding it slightly to the

left and the right by its handle. Close the grill.

Put the filled r

emovable tank into position. Put the bat

teries into the battery holder (ensure that the positive

and negative poles match the + and – marks indicated

on the battery housing). Wait 30 minutes after repla-

cing the tank and batteries before using the heater.

1122bb

1133aa

1177bb

1122aa

1133bb

1144bb

1144aa

1188bb

1188cc

1188aa

1188dd

1199aa

1199bb

1177aa

1166

1155