Operation Manual
GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 53 ff.).
• As a fire precaution, the tank must be filled either
when the heater has been switched off or in
another room than the room where the heater is
installed.
• Always ensure that the tank is closed properly
after filling it at a safe distance from all sources of
heat and open flames (see chapter B).
• The first time the heater is ignited it will smell like
“new” for a short time.
• Store all fuel containers with their original caps
and seals in a cool and dark place.
• Fuel ages. Use new fuel at the start of every
heating season.
• The use of Zibro Extra, Zibro Kristal or Zibro Bio as
a heating fuel assures you that you have a good
quality fuel.
• Before changing brands and/or types of fuel make
sure that the mobile heater first completely
empties all of the remaining fuel inside the
heater.
M
AIN COMPONENTS
OFF - button
Knurled wick
adjustment knob
Ignition button
Combustion
chamber
Combustion
chamber handle
Fuel indicator
Grill
Lid for removable
tank
Removable tank
Fuel gauge
removable tank
Ignition coil
Battery holder
Air quality control
system
Remove all packaging materials (refer to Section A, Fig. A).
Fill the removable tank and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. I).
Insert the batteries into the battery holder
(refer to Section A, Fig. G).
Check whether the combustion chamber is fully upright
(refer to Section A, Fig. F).
Ignite the heater by turning the knurled wick adjustment
knob as far to the right as possible and then gently push the
ignition button (refer to Section C, Fig. K and L).
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
Switch off the heater (refer to Section E).
1
2
3
4
5
6
7
4
51