S1731* - S1735* - S1753* 4 OPERATING MANUAL 2 1 GEBRUIKSAANWIJZING 22 TR KULLANIM KILAVUZU 42
Dear Sir, Madam, Congratulations on the purchase of your Zibro airconditioner. You have acquired a high quality product that, if used responsibly, will give you many years of pleasure. Please read these instructions for use first in order to ensure the maximum life span of your airconditioner. On behalf of the manufacturer, we provide a 24-month guarantee on all material and production defects. Please enjoy your airconditioner. Yours sincerely, PVG International b.v. Customer service department 1.
CONTENTS A Safety instructions 4 B Parts and functions 5 C Before operation 8 D Instructions for use 9 E Air filter 16 F Cleaning 16 G Trouble shooting 18 H Guarantee conditions 19 I Technical data 20 4 3
A SAFETY INSTRUCTIONS Install the device only when it complies with local regulations, by-laws and standards. The unit is only sui- G table for use in dry locations, indoors. Check the mains voltage and frequency. This unit is only suitable for earthed sockets, connection voltage 220 - 240 V. / 50 Hz. IMPORTANT • The device MUST always have an earthed connection. If the power supply is not earthed, you may not connect the unit. The plug must always be easily accessible when the unit is connected.
Do not install in the following places: • Heat or steam is generated in the vicinity. • Under influence by the atmosphere containing in excess salt (in coastal area), sulphide gas (in spa), ammonia, steam of high temperature and vapor. • Air flow from outlet is blocked, for example by snow. • Where oil is dispersed or oil fumes hang over. G B ATTENTION! • Never use the device with a damaged power cord, plug, cabinet or control panel.
Operating panel 1. EMERGENCY OPERATION (manual) SWITCH. To operate the unit if the remote control is not operational. 2. POWER INDICATOR. Lights up when this function is activated. 3. TIMER. Time indicator lights up during preset time. 4. OPERATE. Operating indicator lights up when the unit is in operation. Auto recovery function lf there is any power failure during operation, operation status before power failure is memorized.
Remote Control S1731* - S1735* a TRANSMITTER Sends signals to the receiver of the indoor unit. b FAN SPEED INDICATION Indicates the fan speed selected by the fan speed button. When set at “AUTO”, the fan speed changes automatically according to the difference between the designated temperature and the room temperature. c OPERATION MODE INDICATION Indicates the current operating mode d TIME DISPLAY Indicates the present time or the timer.
C BEFORE OPERATION 1. Operating the Remote Controller Install / Replace Batteries Use two dry alkaline batteries (AAA/LR03). Do not use rechargeable batteries. 1. Remove the battery cover on the back of the Remote Control by pulling it according to the arrow direction shown on the cover. 2. G Insert new batteries making sure that the (+) and (-) of battery are installed correctly. 3. Reattach the cover by sliding it back into position.
a. Open the front panel by pulling upward b. Attach the 3 in 1 filter behind the stopper so that the “FRONT” indication is showing outward. Make sure that the filters are completely behind the stop- 3 in 1 filter pers. If the filters are not attached correctly, it may cause defects. c. D Close the front panel by pushing downward. INSTRUCTIONS FOR USE Present time setting Example: Set to 3:50 p.m. 1. Press the “TIME ADJ” button once 2. Adjust the time with “+”, “-“ buttons.
1. 2. Press the ON/OFF button Set the operation mode, circulating , by pressing the operation mode but- ton. 3. Adjust the setting temperature by pressing the temperature setting buttons. Circulating Operation begins after the room temperature reaches the temperature set by the remote controller. 4. Adjust the fan speed by pressing the fan speed button. When the MODE is set at “AUTO”, the fan speed changes automatically.
G NOTE! • If the unit operates in cooling or dry for a long time in high humidity (i.e., windows and doors are opened), dew and water drops may form on the indoor unit. Be aware that falling drops of water can damage your floor (e.g. carpet or parquet). • If you set a low temperature for dry operation, you may feel the air flow is cold. • During dry mode operation, the system performs the cooling operation until the room temperature reaches 1~2°C above the setting temperature.
Negative ion operation (only on S1731* and S1735*) This function is available only when the air conditioner is operating. 1. Press the ON/OFF button 2. Press the ionizer button To stop negative ion operation, press the ionizer button. Air flow adjustment Horizontal adjustment (all models) When the ON/OFF button is pressed, the horizontal louver will move automatically.
Swing of air flow (horizontallay) If the louver button is pressed once, the horizontal louver will move within the range of the figure above. Fixing the air flow Direction If the louver button switch is pressed again, the horizontal louver will be fixed and that position is memorized. From the next operation the louver will be set at previous position automatically. Vertical adjustment Swing of Air Flow (vertically) The vertical airflow can be adjusted by manually changing the vertical louver blades.
“ON Timer” Example: set the “ON Timer” to 7 a.m. Operation starts at the set time. Programming the “ON Time” 1. Press the “TIME ADJ” 2 times. 2. Adjust the time with the button. The time setting changes in 10-minu- te intervals. Hold the button to fast forward the time. 3. Press the “TIME ADJ” button two times. The setting of “ON Time” is complete and the present time appears. 4. Press the timer fixing button “ON”. The “ON Time” is displayed for 2 seconds and then the present time appears.
Cancelling “OFF Timer” Press the timer fixing button “OFF”. The timer lamp of the indoor unit goes off. “SLEEP Timer” Pressing this button starts the timer mode that will stop the operation after the setting time. Press the “SLEEP” button during the operation. The setting time repeats the following mode by pressing the button: G Continuous operation (Sleep Operation: OFF). The operation stops after passing the setting time.
G NOTE Emergency operation at the temperature between above 23°C and below 26°C just switch the machine in operation in “cooling mode” without actually “cooling”. It is not possible to operate in “Dry” mode. Test operation • Same switch as used in Emergency operation. • Test operation is needed in special occasion when you need to test the “cooling operation” even with the room temperature below 16°C, therefore it is not for the normal operation at all.
Cleaning the filter The 3 in 1 air filter must be cleaned regularly (approximately every 2 weeks) 1. Switch the machine off completely. - Open the front panel (a). - Push up the filter’s center tab slightly until it is released from the stopper, and remove the filters downward. 2. Cleaning the filter. Use a vacuum cleaner to remove dust, or wash the filter with water. After washing, dry the filters completely in the shade. 3. Attach the filters.
G G TROUBLE SHOOTING CAUTION! In the event of a malfunction (burning smell, etc.) immediately stop operation, disconnect the Power Supply plug and consult sales shop. Before requesting service, perform the following checks: The following problems do not always indicate a fault. Please check them before contacting the service department: Problem Cause / Solution The system does not start re-operation immediately. This is for protection of the system.
H GUARANTEE CONDITIONS The air conditioner is supplied with a 24-month guarantee, commencing on the date of purchase. All material and manufacturing defects will be repaired or replaced free of charge within this period. The following rules apply: 1. We expressly refuse all further damage claims, including claims for collateral damage. 2. Repairs to or replacement of components within the guarantee period will not result in an extension of the guarantee. 3.
I TECHNICAL DATA Model S1731 * Type air-conditioner Cooling capacity, nom (min-max)* W Cooling capacity, nom (min-max)* BTU/h EE Class* EER* W/W Heating capacity, nom (min-max)* W Heating capacity, nom (min-max)* BTU/h Heating performance COP* W/W Dehumidifying capacity *** Power consumption cooling, nom Power consumption heating, nom S1735 * S1753 * DC inverter Wall mounted split 2640 (1290-3100) 3315 (1400-3500) 5200 (1500-5300) 9000 (4400-10600) 11300 (4800-11900) 17700 (5100-18000)
Waste electrical products should not be disposed with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. Environmental information: This equipment contains fluorinated greenhouse gases covered by the Kyoto Protocol. It should only be serviced or dismantled by professional trained personnel. This equipment contains R410a refrigerant in the amount as stated in the table above.
DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL B.V. i ÖSTERREICH PVG Austria VertriebsgmbH Salaberg 49 3350 HAAG tel: +43 7434 44867 fax: +43 7434 44868 email: pvgaustria@zibro.com 4 UNITED KINGDOM e BELGIË PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 fax: +32 3 326 26 39 email: pvgbelgium@zibro.com > ITALIA PVG Italy SRL Via Niccolò Copernico 5 50051 CASTELFIORENTINO (FI) tel: +39 0 571 628 500 fax: +39 0 571 628 504 email: pvgitaly@zibro.