Specifications

C
ODE INFORMATION WHAT TO DO
e - 0 Temperature within the heater too high. Cool-down and re-ignite.
f - 0 Power interrupted. Re-ignite the heater.
e - 1 Faulty thermostat. Contact your dealer.
f - 1 Faulty burner thermistor. Contact your dealer.
e - 2 Starting problems. Contact your dealer.
e - 5 Tipping-over protection. Re-ignite the heater.
e - 6 Poor burning. Contact your dealer.
e - 7 Room temperature If necessary,
above 28°C. re-ignite the heater.
e - 8 Defective booster. Contact your dealer.
e - 9 Air filter dirty; or Clean filter
Fuel pump dirty. Contact your dealer.
The heater has been in operation
continuously for a period of 91 hours
and has turned itself off automatically. Switch the heater back on.
-- : -- Out of fuel.
Refill removable tank.
(& blinking
FUEL-light)
-- : -- T
oo little ventilation. Ventilate better.
(& blinking
VENT-light)
e - 1 1 Too little ventilation. Ventilate better.
(& blinking
VENT-light)
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 91 hours continuous operation. The following will then appear
in the display: . If desired, you can switch the heater on again by pressing
the button
M (see Section D).
AUTOMATIC CLEANING MODE
When te heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code
cl:05 running back to cl:00. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the heater
settings. When the heater is burning and the childproof lock is on, the heater can
only be switched of
f. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater.
Activate the childproof lock by pressing the appropriate key N and holding it
down for mor
e than 3 seconds. The KEY-LOCK indicator light will light up (Fig. I),
indicating that the childproof lock has been activated. Switch off the childproof lock
by pressing the key
N and holding it down for more than 3 seconds once again.
J THE CORRECT USE OF 'SA
VE'
The 'SA
VE' function allows you to limit the temperatur
e. When this function is
activated, the heater will automatically switch of
f, when the r
oom temperatur
e exceeds
4
48
I: When the KEY-LOCK
light lights up, the
childproof lock has been
activated.
I
n case of any
malfunctioning the
i
nformation display will
tell you what is the
m
atter.