User manual

Matrix Switching System—User Manual
18
6.0.5.3 LAN Port
AX-88 supports a network RJ45 registered jack using 8P8C modular connector, which
specifies the physical male and female connectors as well as the pin assignments of the
wires in a telephone cable. (A common LAN cable is available.)
Figure 6-11 LAN Port
6.0.5.4 DIP Switcher 8 Pins
Figure 6-12 DIP Switchers
A. DIP Switcher Pin 1 to 5: Switch to up (ON) is specified for “0”, on the other hand to
down (OFF) is specified for “1”. For Device ID settings refer to 6.0.5.6 Device ID Settings.
B. DIP Switcher Pin 6: RS-232/LAN Communication Port Enable/Disable. Only one
matrix device can be connected to other device via RS-232/LAN that is specified as
Master, others are specified as Slave.
ON: RS-485 Serial Master and RS-232 / LAN Enable.
OFF: RS-485 Serial Slave and RS-232 / LAN Disable.
C. DIP Switcher Pin 7: Switch between RS-232 port and LAN port connection.
ON: RS-232
OFF: LAN
D. DIP Switcher Pin 8: Reset the web server IP address to 192.168.0.3
The steps are as below:
1. Please adjust the pin8 to OFF and re-start AX-88.
2. After the AX-88 re-starts about 10sec, shut down your equipment.
3. For a normal operation, please adjust the pin8 to ON, then power on AX-88
again. The IP address will be restored to the default value: 192.168.0.3