User manual

Matrix Switching System—User Manual

 For 0: General selecting, you have to adjust the switcher ID on the rear panel to “0”

that means the device with ID “0” will be upgraded. For 1: Matrix Master selecting will

allow you to select target device based on ID 0 to 31 for firmware upgrading.

4. After finishing firmware upgrade successfully, “Firmware Upgrade to Device

Success” information will appear as below.

The firmware upgrade will not stop even though the web connection suddenly failed.

Check with the LCD screen to confirm the firmware upgrade has been finished

successfully or wait at least 2 minutes then power off to restart your PC.

5. If a firmware already exists on the web server during firmware upgrade. The “Erase

Flash” information screen will appear to notify you to remove the existing firmware

before upgrading the new one.