User guide

010: Optical
6. HDMI IN
7. RS-232
8. IR IN
9. IR OUT
10. IR Connector
LOCAL REAR VIEW
1. ETHERNET(1~4 port RJ-45 Connector with LED)
2. LINK (RJ-45 Connector)
-2-
REMOTE TOP VIEW
1. 1~4 port ETHERNET LINK/SPEED/FULL indicators.
LINK ( Flash : Activity )
SPEED ( ON : 100M, OFF : 10M )
FULL ( ON : Full duplex ,OFF : Half duplex ,
Flash : Collision)
2. POWER LED
3. HDCP LED
4. LINK LED
5. MODE LED
6. IR1 IN ( Internal IR receiver )
REMOTE FRONT VIEW
1. AUDIO IN(R/L)
2. AUDIO IN(COAXIAL)
3. AUDIO IN(OPTICAL)
4. AUDIO SELECT SWITCH
000 : L/R
001: Coaxial
010: Optical
5. HDMI OUT
6. RS-232
7. IR OUT
8. IR2 IN
9. IR Connector
REMOTE REAR VIEW
1. ETHERNET(1~4 port RJ-45 Connector with LED)
2. LINK (RJ-45 Connector)
-3-
Installation
1. Be sure to turn OFF your HD source and HDTV.
2. Connect the HDMI extension cable between HD source
and the “HDMI IN” port of Transmitter.
3. Connect the HDMI extension cable between the HDTV
and the “HDMI OUT” port of Receiver.
4. Connect CAT.5 cables between the Transmitter “LINK”
port and the Receiver “LINK” port of extender.
5. Connect the power cord and power up the extender.
6. Turn on your HD source and HDTV.
IR Receiver
Pin configuration for 3.5mm IN terminal
GND
+V
Sig
DO NOT PLUG MONO TIPE IR EMITTER INTO “IR-IN”
IR-in is design to be used with IR receivers.