Use and Care Manual

TECHNICAL DATA
BULLS-EYE
®
SHELLAC
Rust-Oleum Corporation Form: GDH-214
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 012814
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
BULLS-EYE SHELLAC
Resin Type
Shellac
MIR
1.00 Max
NA
Fill Weight
12 ounces
NA
Solvents
Acetone, Denatured Alcohol, Ethanol
Denatured Alcohol, Ethanol, Water
Weight
Per Gallon
NA
7.3 lbs.
Per Liter
NA
0.86 kg
Solids
By Weight
NA
25.6%
By Volume
NA
19.3%
Volatile Organic Compounds
NA
<625 g/l
(5.2 lbs./gal.)
Theoretical Coverage at
1 mil DFT (25µ)
NA
310 sq.ft./gal.
(7.6 m
2
/l)
Practical Coverage at
Recommended DFT (assume
15% material loss)
8-10 sq.ft./can
(0.7-0.9 m
2
/can)
100-150 sq.ft./quart (2.5-3.7 m
2
/l)
depending on application method and
surface porosity
Dry Times at 70°F
(21ºC) and 50%
Relative Humidity
Touch
30 minutes
30 minutes
Recoat
1 hour
1 hour
Full Cure
24 hours
24 hours
Shelf Life
3 years
3 years
Flash Point
-156°F (-104°C)
60ºF (16ºC)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.