Use and Care Manual

TECHNICAL DATA
B-I-N
®
SHELLAC-BASE PRIMER ULTIMATE STAIN BLOCKER
Rust-Oleum Corporation Form: GDH-71
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 111413
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
B-I-N Shellac-Base Primer-Sealer/Stain Killer Bond Coat
Resin Type
Shellac-Base
Pigment Type
Titanium Dioxide
Solvents
Denatured Alcohol, Water
Weight
Per Gallon
9.8 lbs.
Per Liter
1.17 kg
Solids
By Weight
51.0%
By Volume
29.0%
Volatile Organic Compounds
Max. 550 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.0-1.5 mils
(25-37.5µ)
Wet Film to Achieve DFT (Unthinned
material)
3.0-4.0 mils
(75-100µ)
Theoretical Coverage at
1 mil DFT (25µ)
565 sq.ft./gal.
(13.9 m
2
/l)
Practical Coverage at
Recommended DFT (assume 15%
material loss)
Approximately 500 sq.ft./gal. (12.3 m
2
/l)
depending on application method
and surface porosity
Dry Times at 70°F
(21ºC) and 50%
Relative Humidity
Touch
20 minutes
Recoat
45 minutes
Full Cure
1-3 days
Shelf Life
3 years
Flash Point
54ºF (12ºC)
Flame Spread (ASTM-84-97A)
0, Class 1
Smoke Contrib. (ASTM-84-97A)
5, Class 1
MPI Certified
#36, 46
Storage
Store indoors at 40-80°F (4-27°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.