MSDS

Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain
and nervous system damage.
Contains crystalline silica as silicon dioxide. Excessive inhalation of respirable crystalline silica dust may cause
lung disease, silicosis or lung cancer. Significant exposure is not anticipated during brush or trowel application or
drying. Risk of overexposure depends on the duration and level of exposure to dust from repeated sanding of
surfaces, mechanical abrasion or spray mist and actual concentration of crystalline silica in the formula.
Crystalline silica is listed as Group 1 "carcinogenic to humans" by the International Agency for Research on
Cancer (IARC), and Group 2 "reasonably anticipated to be a carcinogen" by the National Toxicology Program
(NTP).
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Flash Point: 63 F (Setaflash)
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: Isolate from heat, electrical equipment, sparks and open flame. Vapors may
form explosive mixtures with air. Vapors can travel to a source of ignition and flash back.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance. Water may be used to cool
closed containers to prevent pressure buildup and possible autoignition or explosion.
Steps To Be Taken If Material Is Released Or Spilled: Eliminate all ignition sources; use explosion-proof
equipment. Place material in a container and dispose of according to local, provincial, state and federal
regulations. Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
Handling: Follow all MSDS/label precautions even after container is emptied because it may retain product
residues. Use with adequate ventilation. Wash thoroughly after handling. Wash hands before eating.
Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep
away from heat, sparks, flame and sources of ignition. Keep container closed when not in use.
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Page
2
of
5
904 BIN QT 6 PK PRIMER
5/4/2011
file://O:\Program%20Files\ProductVision%204.0\REPORTS\~PV26345.htm