Use and Care Manual

TECHNICAL DATA
PERMA-WHITE
®
MOLD & MILDEW-PROOF
™
INTERIOR PAINT
Rust-Oleum Corporation Form: GDH-76
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 102016
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
PERMA-WHITE MOLD & MILDEW-PROOF INTERIOR PAINT
Resin Type
Water-based Acrylic
Pigment Type
Titanium Dioxide, Zinc Oxide
Solvents
Water, Glycol Ethers
Weight
Per Gallon
11.6 lbs.
Per Liter
1.39 kg
Solids
By Weight
51.0-57.0%
By Volume
38.0-41.0%
Volatile Organic Compounds
<50 g/l (0.42 lbs./gal.)
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.0 mils
(37.5-50µ)
Wet Film to Achieve DFT (Unthinned
material)
3.5.0-5.0 mils
(87.5-125µ)
Practical Coverage at Recommended
DFT (assume 15% material loss)
Approximately 300-400 sq.ft./gal. (7.4-9.8 m
2
/l)
depending on application method and surface porosity
Dry Times at 70°F
(21ºC) and 50%
Relative Humidity
Touch
30 minutes
Recoat
2 hours
Full Cure
7-10 days
Shelf Life
5 years
Flash Point
>200ºF (93ºC)
Storage
40-80°F (4-26°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.