MSDS

ManualsBrandsZinsser ManualsPaint1-gal. Perma-White Mold and Mildew-Proof Satin Interior Paint (2-Pack)

Material Safety Data Sheet

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated

PermaWhite Interior Satin MSDS (3-20-07) page 1 of 6 pages.

Section 1 General Information

Manufacturer:

Zinsser Company, Inc.

173 Belmont Drive

Somerset, NJ 08875

(732) 469-8100

Emergency Telephone: Chemtrec (800) 424-9300 Date: March 20, 2007

Product Name: PermaWhite

Mold & Mildew Proof* Interior Paint

Gloss Level: Satin

Product Codes: 02700 02702 02704 02705 02711

Section 2 Hazardous Ingredients

OSHA ACGIH

Hazardous Component CAS# PEL TLV

Calcium Carbonate 471-34-1 15 mg/m

* (5 mg/m

**) 10 mg/m

✝

(3 mg/m

**)

Limestone 1317-65-3 15 mg/m

* 5 mg/m

** 10 mg/m

Talc 14807-96-6 20 mppcf 1 mg/m

Titanium Dioxide 13463-67-7 15 mg/m

* 10 mg/m

Zinc Oxide 1314-13-2 15 mg/m

* (5 mg/m

**) 2 mg/m

(10 mg/m

STEL)

* Total Dust ** Respirable Dust Fraction

Section 3 Hazard Identification

Product Overview: This material is a wall paint. It is a stable, non-flammable, white flowable

liquid with a flashpoint above 200° Fahrenheit.

Primary Routes of Exposure:

Eye Contact

Skin Contact

Inhalation

Potential Acute Health Effects:

Eye: May cause eye irritation.

Skin: Prolonged contact may cause skin irritation. Absorption through skin contact not

considered a significant route of exposure.

Summary of content (6 pages)

PAGE 1
Material Safety Data Sheet Section 1 General Information Manufacturer: Zinsser Company, Inc.
PAGE 2
Ingestion: Although ingestion not considered a significant route of exposure, Gastrointestinal irritation and nausea may occur if swallowed. Inhalation: Although inhalation is not considered a significant route of exposure, high vapor concentrations may cause respiratory irritation. Potential Chronic Health Effects: None known. (See also Sections 4, 8, and 11 for related information) Section 4 First Aid Measures Eye contact: Flush eye with water for 15 minutes. Get medical attention.
PAGE 3
Section 7 Handling and Storage Handling: Avoid contact with eyes, skin, and clothing. Storage: Keep from freezing. Keep container closed when not in use. Section 8 Exposure Controls / Personal Protection Engineering Controls: If exposure conditions warrant, use mechanical local exhaust ventilation or general dilution ventilation to reduce vapor concentrations. Personal Protective Equipment (PPE): Eye Protection: Wear safety glasses or face shield to prevent eye and face contact.
PAGE 4
Hazardous Decomposition Products: Hazardous Conditions to Avoid: Incompatibility: None known. None known. None known. Section 11 Toxicological Information Carcinogenicity: The following ingredients are present at greater than 0.1% and are classified by IARC, NTP, or OSHA as carcinogenic: Ingredient None CAS # N/A IARC N/A NTP N/A OSHA N/A (See also Section 15 for related information) Section 12 Ecological Information Chemical Fate and Effects: No data available.
PAGE 5
SARA Title III, section 311/312: The Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III requires emergency planning based on Threshold Planning Quantities (TPQs) and release reporting based on Reportable Quantities (RQs) in 40 CFR 355 (used for SARA 302, 304, 311 and 312). Components present in this product at a level which could require reporting under the statute are: Chemical Name None CAS# N/A Maximum Concentration (Wt.
PAGE 6
Prepared By: Zinsser Health and Safety Manager, Regulatory Compliance Dept. 173 Belmont Drive Somerset, NJ 08875 (732) 469-8100 Disclaimer: Zinsser Co., Inc. believes, to the best of its knowledge, information and belief, the information contained herein to be accurate and reliable as of the date of this material safety data sheet.