How to Guide

TECHNICAL DATA
COVER STAIN
®
OIL-BASED PRIMER
Rust-Oleum Corporation Form: GDH-137
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 110816
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
COVER-STAIN OIL-BASED PRIMER
Resin Type
VT Styrenated Modified Alkyd
Pigment Type
Calcium Carbonate, Magnesium Silicate, Titanium Dioxide
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
11.1 lbs.
Per Liter
1.33 kg
Solids
By Weight
68.6%
By Volume
45.6%
Volatile Organic Compounds
450 g/l (3.77 lbs./gal.)
Recommended Dry Film
(DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Wet Film to Achieve DFT (unthinned
material)
2.0-3.0 mils
(50-75µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
400-450 sq.ft./gal. (9.8-11.1 m
2
/l)
Depends on surface porosity and application method
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
30 minutes
Recoat
1 hour
Full Cure
7 days
Shelf Life
5 years
Flash Point
83ºF (28ºC)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.