Technical Specifications

TECHNICAL DATA
BULLS-EYE 1-2-3 WATER-BASED PRIMER
2
Form: CS1245
Rev.: 080112
.PRODUCT APPLICATION (cont.) . .
MIXING
Brush Goods - Mix thoroughly to ensure any settled pigment
is re-dispersed. DO NOT THIN.
APPLICATION
Apply only when air, material, and surface temperatures are
between 50-90ºF (10-32ºC) and the surface temperature is at
least 5ºF (3ºC) above the dew point. The r elative humidity
should not be greater than 85%.
Brush Goods - Mix thoroughly to ensure any settled pigment is
re-dispersed before using. In most cases only one coat is
necessary to prime most surf aces. If excessive absorption
occurs over very porous substrates a second coat may be
necessary. Spot priming is recommended only under high-
hiding topcoat paints. For best r esults, prime entire surface
before painting. Apply with a natural or synthetic bristle brush,
roller, pad or sprayer. Follow manufacturer's instructions
when using spray equipment. Airless spr aying - use a .017"
tip at 2000 to 2500 P.S.I.
Aerosol - Shake can vigorously for one minute after the
mixing ball begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Cont act Rust-Oleum. Shake often during use.
Hold can upright 10-16” from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke. Keep
the can the same distance from the surface. Keep the can in
motion while spraying. Apply two or more light coats a few
minutes apart to avoid drips and runs. Do not use near
open flame.
CLEAN-UP
Brush Goods - Clean up spills and paint drips with warm
water and liquid detergent. W ipe up splatt ers before they dry.
Follow manufacturer’s directions to clean spray equipment.
Dispose of unused or unwanted product in accordance with
local laws regulating solvent-based coatings.
Aerosol - W ipe off tip before storing. Clean-up wet paint with
xylene or mineral spirits. Properly discard empty container.
Do not burn or place in home trash compactor. If the valve
clogs, twist and pull off spray tip and rinse in a solvent such
as mineral spirits. Do not insert any object into can valve
opening.