Use and Care Manual

TECHNICAL DATA WTP-01
OIL-BASED ORANGE PEEL
WALL TEXTURE SPRAY
Form: GDH-1216
Rev.: 060217
1
.DESCRIPTION AND USES .
Zinsser
®
Oil-Based Orange Peel Wall Texture Spray is
designed to create an orange peel texture quickly and
easily. Orange Peel Wall Texture Spray is easy to apply
and dries quickly. It is great for repairs and patches on
already textured walls.
.FEATURES .
• Controlled spray
• Fast dry
• Repairs damaged texture
PRODUCTS .
SKU (20 oz.) Description
202129 Bright White Fine Texture
202131 Bright White Medium Texture
PRODUCT APPLICATION .
PAINTING CONDITIONS
Use in a well ventilated area. Use when temperature is
between 50°F (10°C) and 90°F (32°C) and humidity is
below 85% to ensure proper drying. Avoid spraying in very
windy and dusty conditions. Cover surrounding area to
protect from overspray.
SURFACE PREPARATION
Complete any necessary surface repairs. For best results,
prime and seal the surface before painting.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-Approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
TESTING SPRAY PATTERN
Practice spraying texture onto cardboard or scrap drywall
to determine the best distance and pressure to deliver the
preferred pattern.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 24-36” from surface and begin
spraying in a quick circular or quick sweeping motion that
evenly covers the surface. Keep the can in motion while
spraying.
Do not use near open flame.
DRY & RECOAT TIMES
Dry times are based on 70°F and 50% relative humidity.
Allow more time at cooler temperatures. Dries to the touch
in 5-15 minutes, to handle in 8-20 minutes and can be
topcoated in 30 minutes. Heavier textures may take more
time to dry.
CLEAN-UP
After use, turn can upside down and press spray nozzle
until the spray mist is clear to prevent clogging. Wipe off
tip before storing. Clean-up wet paint with water. Properly
discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse it in
water. Do not stick a pin or other objects into the valve
stem.