MSDS

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated
Shieldz Clear MSDS (04-15-05) Page 2 of 6 pages.
Signs and Symptoms: None known.
(See also Sections 4, 8, and 11for related information)
Section 4 First Aid Measures
Eye contact: Flush eye with water for 15 minutes. Get medical attention.
Skin contact: Wash with soap and water. Get medical attention if symptoms occur.
Ingestion: Do not take internally. If swallowed, call a physician or poison control center.
Inhalation: No specific treatment is necessary since this material is not likely to be
hazardous by inhalation. If exposed to excessive levels of vapor, remove victim to fresh
air and seek medical attention if cough or other symptoms develop.
Note to Physician: This material is basically non-toxic. A small quantity (approximately one-
tablespoon) is unlikely to cause harm.
Section 5 Fire Fighting Measures
Flash Point (method): Not Determined (expected to be above 200° F based on ingredients).
Extinguishing Media: Use water spray, foam, or carbon dioxide when fighting fires
involving this material.
Protection of Firefighters: As in any fire, wear self-contained breathing apparatus in pressure
demand mode and full protective gear.
Fire and Explosion Hazards: The liquid material will not burn. However, the dried paint
film may burn in a fire.
Section 6 Accidental Release Measures
Clean Up Methods: Keep unnecessary people away. Dike and contain spill with inert material
(sand, earth, etc.). Transfer liquid to containers for recovery or disposal, or absorb with
absorbent materials and place into containers for disposal. Keep spill out of sewer and open
bodies of water. Floors may be slippery; care should be exercised to avoid falls during clean up
operations.
(See also Section 8 for information on Exposure Controls and Personal Protective Equipment)
Section 7 Handling and Storage
Handling: Avoid contact with eyes, skin, and clothing.