Technical Specifications
11 Hawthorn Parkway
Vernon Hills, IL 60061
Technical Data Bulletin
WATERTITE
™
HYDRAULIC CEMENT
For Concrete & Masonry
Description:
WATERTITE HYDRAULIC CEMENT is used to stop water flow and permanently
10lbs. 2.5lbs.
seal deep cracks and holes in all grades of concrete. It plugs, seals and creates a “watertight” seal in 5 minutes, even
while water is flowing. Also, use as anchoring cement. Use for interior and exterior surfaces.
Suitable Substrates:
Concrete block, cast-in-place concrete, stucco, tilt-up, exposed aggregate, slump block
Suitable Uses:
Basement & cellar walls, expansion and control joints, curtain wall joints, windows, doors, panels, fountains,
reflecting pools, planters, canals, retaining walls, privacy fences
Features:
•
Plugs and seals deep holes in concrete and masonry
•
Creates “watertight” seal in 5 minutes – even as water is flowing (stops active and non-active leaks)
•
Use on interior and exterior concrete and masonry surfaces
•
Can be used as an anchoring cement
Physical and Chemical Characteristics:
Working time – 3 to 5 minutes
Setting time – 5 minutes
Final cure – 28 days
See MSDS sheet for particulars.
Directions for Use:
Surface Preparation and Application - Chisel holes to enlarge them by at least ¼” and scrape clean. Remove any loose or
chipped concrete. Make sure that the surface to be patched is damp. Mix two parts WATERTITE HYDRAULIC CEMENT
to one part water. Stir the mixture until it reaches a putty-like paste. Mixture will begin to set in 3 to 5 minutes. Only mix
as much material as you can use at one time. Hold mixture compound in gloved hand until it becomes warm. Force it
firmly into the hole or crack and hold in place for 5 minutes. Immediately trim or brush away any excess cement for a
smooth finish.
Important: Wear eye protection and rubber gloves when working with WATERTITE HYDRAULIC CEMENT.
For Best Results:
• Always apply to a damp surface
• Apply from the top of the opening down
• Keep the patched area damp for several hours after the application
• If paint is desired, always use a good quality latex-based or masonry paint for a professional finish
•
Always follow manufacturers application directions
Wash skin and hands with soap and water. Cured material must be scraped away.