Use and Care Manual
TECHNICAL DATA WRT-08
WATERTITE
®
HYDRAULIC CEMENT
Form: GDH-194
Rev.: 100115
1
.DESCRIPTION AND USES .
WaterTite
®
Hydraulic Cement is designed to stop water
flow and permanently seal deep cracks and holes in all
grades of concrete. It plugs, seals and creates a
“watertight” seal in 5 minutes, even while water is flowing.
It can be used on concrete block, cast-in-place concrete,
stucco, tilt-up, exposed aggregate and slump block and
can be used as an anchoring cement. It is suitable for use
on basement floors and cellar walls, expansion and control
joints, curtain wall joints, windows, doors, panels,
fountains, reflecting pools, planters, canals, retaining walls
and privacy fences.
.FEATURES .
Plugs and seals deep holes in concrete and masonry
Creates a watertight seal in 5 minutes (stops active
and non-active leaks)
Use on interior and exterior concrete and masonry
surfaces
Can be used as an anchoring cement
.PRODUCTS .
SKU Container Size
5071 10 pounds
5074 2.5 pounds
.PRODUCT APPLICATION .
SURFACE PREPARATION
IMPORTANT – Wear eye protection and rubber gloves
when working with WaterTite Hydraulic Cement. Chisel
holes to enlarge them by at least ¼” and scrape clean.
Remove any loose or chipped concrete. Make sure the
surface to be patched is damp.
PRODUCT APPLICATION (cont.) .
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-Approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
APPLICATION
Mix two parts WaterTite Hydraulic Cement to one part of
water. Stir the mixture until it reaches a putty-like paste.
Mixture will begin to set in 3 to 5 minutes. Only mix as
much material as you can use at one time. Hold mixture
compound in gloved hand until it becomes warm. Force it
firmly into the hole or crack and hold in place for 5
minutes. Immediately trim or brush away any excess
cement for a smooth finish.
CLEAN UP
Wash skin and hands with soap and water. Cured material
must be scraped away. Be sure the container lid is closed
and tightly sealed. Store in a cool, dry place.
KEEP OUT OF REACH OF CHILDREN.