User's Manual

Zinwave 2700 DAS – User Manual
Issue 1.2
April 2007
© Zinwave Ltd. 2007
2.4.3 Use the ZinConfig utility tool
o To launch ZinConfig double click on the desk top icon or
click Start >Programs >Zinwave->ZinConfig
 section 4.2.2
o The default community for read/write access is “private”,
for read-only access is “public”. These are configured
through the CLI.
 section 4.3.4.2
o Specify the IP address range (Start IP address / End IP
address) of your attached Hub Units and press “Find
Hubs” to load them into ZinConfig.
 section 4.2.3
o Select the HU which you wish to configure (and the AUs
attached to it).
o Press “Discover AUs” to associate the connected AUs to
the HU
 section 4.2.4
o Adjust the HU signal distribution, the HU gain settings and
the AU gain settings according to you r system design.
 section 4.2.6
 section 4.2.7