User's Manual

Zinwave 2700 DAS – User Manual
Issue 1.2
April 2007
© Zinwave Ltd. 2007
4.2.8 Status and Alarms
When an alarm is present, the SFP port
or the status box in the AU frame is
colored red. Status and alarm
information is displayed by left-clicking
on one of the colored boxes.
Alternatively status information on the
SFP ports can be displayed by right-
clicking on the SFP port and selecting
“Alarms” from the pop-up menu (Figure
4-7).
Clicking on one of the SFP ports displays
information on the HU SFP. Clicking on
the colored box in the AU frame displays
information on the AU optical transceiver
Figure 4-7: Reading out alarms on the optical link.
A box will appear describing the
alarm if present together with a
range of status information
(Figure 4-8). The displayed
parameters are:
o RX optical power
o TX optical power
o Laser bias current
o SFP supply voltage
o SFP temperature
Figure 4-8: Alarm description.
4.3 Control via Command Line Interface (CLI)
A detailed description of the full CLI functionality can be found in Zinwave 2700 DAS –
Software Manual.
The CLI can be accessed directly with an RS-232 serial connection, or remotely
through a network using the Telnet protocol.