User's Manual

7
LED
Power LED
Green
ON
: Power on and ready.
BLINKING: ( 0.5 sec ON / 0.5 sec OFF )
1. During Group pairing procedure. In this procedure, the device
joining or being joined into same logical network will continue 2
minutes’ blinking, until the procedure succeeds or is canceled). To
enter or cancel Group pairing procedure, just press the GROUP
button 2~3 sec.
OFF
: Power off.
PLC LED
Green
ON
: Powerline Link detected but no powerline traffic.
BLINKING
:
1. Fast blinking (0.06 s ON/ 0.06 s OFF): Powerline data rate higher
than 80Mbps.
2. Normal blinking (0.2 s ON/ 0.2 s OFF) Powerline data rate between
40Mbps to 80Mbps.
3. Slow blinking (1 s ON/ 1 s OFF): Powerline data rate slower than
40Mbps.
OFF
: Powerline Link not detected (either other devices in same network
is too far to communicate or it is alone in its logical network).
WLAN LED
Green + Red
Steady Green: Wi-Fi active under security protection
Flash Green: Wi-Fi transmits packets under security protection,
Steady Red: Wi-Fi active under NO security protection,
Flash Red: Wi-Fi transmits packets under NO security protection,
BLINKING Green (0.5 sec ON / 0.5 sec OFF): WPS negotiation
OFF：Wi-Fi off
Ethernet LNK/ACT
LED
ON
: Ethernet Link Detected.
BLINKING
: Ethernet traffic detected.
OFF
: No Ethernet Link detected.
Buttons
LANport

PowerOn/Off
