User's Manual

7
Caution: DON’ T plug the power cord into PoE device before you finish install
the antenna and Ground wire to ensure the safety.
If the RJ-45 cable’ s length is not long enough to connect to your network
device for indoor parts installation, you can extend the cable length.
However, make sure the maximum length of the RJ-45 cable is shorter than
100M (about 109 yards) for normal operation under IEEE 802.3 standards.
When you plug the regular RJ -45 cable into the PoE device, you should use
the regular RJ-45 cable to plug into the “ DATA IN” of “ Power Over Ethernet Kit”
to connect to hub/switch or use the crosslink RJ-45 cable (Not included in the
Packing List) to connect with user’ s PC.
The waterproof RJ-45 cable must be connected to the “ P+DATA OUT” port.
Caution: Be careful! Don’ t plug the two cables inversely. It will damage the
devices!
We recommend you refer to the following illustration as a guideline for
hardware installation.