User's Manual

9
4. Plug the other end of the RJ-45 network cable to “P+ DATA OUT” port of PoE device.
The PoE device is guaranteed only in indoor environment.
Caution: DON’T plug the power cord into PoE device before you finish install the
antenna and Ground wire to ensure the safety.
Make sure the maximum length of the RJ-45 cable is shorter than 100M (about 109 yards)
for normal operation under IEEE 802.3 standards.
When you plug the regular RJ-45 cable into the PoE device, you should use the regular
RJ-45 cable to plug into the “DATA IN” of “Power Over Ethernet Kit” to connect to
hub/switch or use the crosslink RJ-45 cable (Not included in the Packing List) to connect
with user’s PC.
The RJ-45 network cable must be connected to the “P+DATA OUT” port.
Caution: Be careful! Don’t plug the two cables inversely. It will damage the devices!
And you have to use our PoE (included in the packing list) to guarantee that
power supply is normal.
LED Panel