User's Manual

17
Ch 2. First Time Configuration
Before Start to Configure
There are two ways to configure the device, one is through web-browser, and the other is
through Secure Shell CLI interface. To access the configuration interfaces, make sure
you are using a computer connected to the same network as the device. The default IP
address of the device is 192.168.2.254, and the subnet-mask is 255.255.255.0.
The device has three operation modes (Router/Bridge/WISP). In bridge mode, also
known as AP Client, you can access the device by both WLAN (Wireless Local Area
Network) and wired LAN. And in router/WISP modes, the device can be accessed by
both WLAN and WAN. The default IP addresses for the device are 192.168.2.254(for
Internet
Ethernet
HUB/SWITCH
ADSL
Ground
Outdoor Indoor
Power
Injector
Power
Supply
RJ-45
48V in
Antenna