User's Manual

Note: When the WPS is enabled, the authentication mode is left only Open,

WPA Personal and WPA2 Personal for configuration.

WPS Configuration Steps

1. Setup the Wireless Security: We recommended you to setup Wireless

Security before setting WPS; otherwise it will use no encryption after you

setup and start WPS. Please refer to the section of wireless security

mentioned in this guide book.

2. Enable WPS setting: Check the Enable box and then submit to apply.

You can choose either step 3 PIN or step 4 PBC to setup WPS. It only

supports the first SSID.

3. PIN setup:

Open the WPS page on the configuration tool of the WLAN Client

(station) and read the Pin Code for WPS. Select the WPS Config Method

“PIN- Personal Identification Number” and enter the Pin Code in the text

field “Add Enrollee PIN code”, and then click the button “Start WPS

Config”. The WLAN client will get associated in a few seconds.

4. PBC setup:

You could toggle PBC through WPS button in the front panel or click the

“Start WPS Config” in the WPS setup page.

z WPS button: Press the button for 5 seconds and then press “PBC”

option on the configuration tool of the WLAN Client (station). The client

will get associated in a few seconds.

z Start WPS Config: Select the option “PBC –Push Button