User Manual

8
WLAN: The LED flashes when WLAN is working.
WPS LED: The LED lights when the WPS button is pushed.
WPS Button: Press it to enable PBC (Press Button Communication) for WPS
authentication.
Back Panel
From left to right:
WAN: You can connect the Ethernet port from ISP such as ADSL ITU-R, Cable MODEM.
LAN 1/2/3/4: 4 Ethernet ports for the LAN connection.
POWER: Please supply the power in 12V and 1A.
Reset Button: Press Reset button to revert it to factory default.
Antenna port: For ZW-N5900S, there are two antenna ports (RP-SMA type) in the both
ends of this side. Connect the antenna into the port.
For ZW-N5900C, the antennas are fixed to the device. Please adjust the
angle of antenna for the better radio receives.
Hardware Installation
Once you check everything from the package, you can start to install the device. You can
use the wall mount hole on the bottom of the device to mount the device on the wall, or
just put the device on the desktop. The administrator can refer to the figure below while in
the process of constructing your WLAN environment.