User's Manual

RJ-45 Cable 6 dBi omni directional antenna

2.5” /4” U bolt and Anchor

Hardware Installation

Once you check off everything from the package, you can start to install the

ODU. You can mount to a pipe, a pole or to the side of a building. The

steps are showed in the following：

1. You must mount the ODU into the bracket first.

Note:

ALL the 4 screws had been tightened onto the ODU and

bracket

2. You can use the 2 or 4 inches U bolt to mount on the pipe, depending on

the radius of the pipe. (Wall mounting is referred to Wall Mounting

Figure) The two U bolts must be mounted tightly. Be aware of not

over-tighten the U bolt.

Pipe Mounting Figure