User's Manual

47
Whole System Flood: ICMP IP TearDrop
Per-Source IP Flood: SYN PingofDeath
Per-Source IP Flood: FIN TCP Scan
Per-Source IP Flood: UDP TCP SynWithData
Per-Source IP Flood: ICMP UDP Bomb
TCP/UDP PortScan UDP EchoChargen
Sensitivity: you can select Low or High sensitivity.
You can click Select ALL or Clear ALL to select prevention type.
5.5 Management
5.5.1 Upgrade Firmware
New version of firmware will be released to improve the various efficiency or to fix some
bugs. Following the steps show below so as to realize upgrading. This page allows you to
upgrade the Access Point firmware to new version.
Please note: DO NOT power off the device during the upload because it may crash the
system.
Firmware version: shows the current firmware version.
Choose File: select the firmware version you want to upgrade on your computer.
Click Upload to upgrade the firmware version.
5.5.2 Save/Reload Setting
This page allows you to save current settings to a file or reload the settings from the file
which was saved previously. Besides, you can reset the current configuration to factory