Installation Guide

Guide to Loading and Unloading the

ZIP System

™

Tape Gun

Note: You can easily and efﬁ ciently install the new linerless tape with your current ZIP System

™

Tape Gun.

There’s no need for new equipment. (See reverse side for details.)

TAPE GUN

Step 3. Push lever to lock tape roll into place.

Step 2. Place tape roll onto unwind spool so the

leading edge unwinds counterclockwise.

Step 5. Pull tape underneath pressure roller with

enough excess to begin applying to panel

seam. Pull tape gun to dispense. Pressure

roller imprint (diamond pattern) should be

observed on tape.

See reverse side for information on how to unload the

empty tape roll.

Step 1. Pull the lever inside the unwind spool prior

to loading tape roll.

Step 4. Feed leading edge underneath the bottom of

the take-up spool and toward pressure roller.

Linerless Tape Loading

PAGE 1
Guide to Loading and Unloading the ZIP System™ Tape Gun TAPE GUN Note: You can easily and efficiently install the new linerless tape with your current ZIP System™ Tape Gun. There’s no need for new equipment. (See reverse side for details.) Linerless Tape Loading Step 1. Pull the lever inside the unwind spool prior to loading tape roll. Step 4. Feed leading edge underneath the bottom of the take-up spool and toward pressure roller. Step 2.
PAGE 2
Guide to Loading and Unloading the ZIP System™ Tape Gun TAPE GUN Lined Tape Loading Step 1. Follow Steps 1-3 on reverse side to load tape roll, then open liner clamp and separate approximately 4" of liner from tape roll. Step 3. Feed tape over the top of the take-up spool and under the pressure roller. Step 2. Feed liner onto the take-up spool and close liner clamp so it snaps shut.