Installation manual

4. Installation Setup
4. INSTALLATION SETUP
Overview
• Connecting the Optical and Electronic Block together
• Scan Adaptation
WARNING: RISK OF ELECTRIC SHOCK! TURN OFF THE PROJECTOR AND UNPLUG THE POWER CORD!
This installation should only be done by BARCO authorized service personnel.
4.1 Connecting the Optical and Electronic Block together
Preparation to connect the cable tube
1. Loosen both indicated screws on the back of the electronic block.
Electronic block
Image 4-1
Loosen both indicated screws on the back of the electronic block
2. Remove the protection plate on the back.
Electronic block
Image 4-2
Remove the protection plate on the back
3. Loosen both indicated screws on the back of the optical block.
Optical block
Image 4-3
Loosen both indicated screws on the back of the optical block
4. Remove the protection plate on the back.
Optical block
Image 4-4
Remove the protection plate on the back
5. Loosen the 4 indicated screws on each side of the optical block.
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003
19