Installation manual

4. Installation Setup
O
p
tical block
Image 4-5
Loosen the 4 indicated screws on each side of the optical block
6. Loosen the 4 indicated screws on the back of the optical block.
Opt
i
ca
l
b
l
oc
k
Image 4-6
Loosen the 4 indicated screws on the back of the optical block
7. Remove the protection plate on the top.
Optical block
Image 4-7
Remove the protection plate on the top
Connecting the cable tube to the optical block
The cable tube contains 6 cables, each with his own connector. Make sure to connect the side with the longest EHT cable to the
optical block. There is an opening to mount the cable tube in on the right and left side of the block. The unused opening is closed
withaprotectionplate.
1. Loosen the fastener ring on the side off the cable t
ube with the longest EHT cable.
Image 4-8
Loosen the fastener ring on the
side off the cable tube with the longest EHT cable
1 EHT connector (longest cable) to Optical Block
1’ EHT connector (shortest cable) to Electronic Block
2 RGB BNC connectors
3 Signal/Data connectors
2. Put the cable tube connector through the opening, the cable tube can be connected on the right or the left side
20
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003