Installation manual

4. Installation Setup
Image 4-9
Put the cable tube connector through the opening
3. Tighten the fastener ring so that the cable tube is secured to the block.
Image 4-10
Tighten the fastener ring so that the cable tube is secur
ed to the block
4. Put the EHT cable through the opening at the back of the optical block, inside the projector make sure to guide the cable UNDER
the picture tube unit and connect this cable to the EHT connection on the EHT block.
Image 4-11
Connecting the EHT cable
5. Connect the RGB cables to the BNC connectors on the back of the optical block , the cables and connectors are marked with
their respective colors.
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003
21