Installation manual

4. Installation Setup
Image 4-12
Connecting the RGB cables
6. Connect the Signal and Data cables to the corresponding connectors on the back of the optical block. Interchanging of the two
36 pin connectors is prevented by a build_in key in the female connectors. (When these cables need to be unplugged, push the
tabs on the sides of the connector and pull backwards)
Image 4-13
Connecting the Data and Signal cables
J1 36 pin connector with white wires
J2 36 pin connector with green wires
J3 24 pin connector with grey wires
7. Put the protection plates back in place.
Connecting the cable tube to the electronic block
1. Loosen the fastener ring on the cable tube.
Image 4-14
Loosen the fastener ring on the cable tube
1 EHT connector (longes
t cable) to Optical Block
1’ EHT connector (shortest cable) to Electronic Block
2 RGB BNC connectors
3 Signal/Data connec
tors
2. Put the cable tube connector through the opening, the cable tube can be connected on the right or the left side.
22
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003