Installation manual

4. Installation Setup
Image 4-18
Connecting the RGB cables
6. Connect the Signal and Data cables to the corresponding connectors on the back of the electric block.
Image 4-19
Connecting the Data and Signal cables
J1 36 pin connector with white wires
J2 36 pin connector with green wires
J3 24 pin connector with grey wires
7. Put the protection plate back in place.
4.2 Scan Adaptation
Scan Connectors
The scan connectors must be placed in the correct position which correspond to the desired scanning configuration.
Access to the Scan Connectors
The get access to the scan connectors it i
s necessary to lift up the protection plate on the top/back of the electric block.
1. Loosen the indicated bolts, 3 on each side and 2 on top.
24
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003