Installation manual

4. Installation Setup

3 blots on the left

3 blots on the right

2 blots on top

Image 4-20

Loosen the indicated bolts

2. Lift up the protection plate.

Image 4-21

Lift up the protection plate

3. The connectors are located at the top/back of the electronic block.

Scan Connector Settings

When changing the horizontal and/or vertical scan, insure that all three connectors are set in the same position. The configuration

of each connector is depending on its orientation i.e. on the position of the reference side of the connector. The position of the scan

connectors for the different mounting configurations can be summarized as follows:

R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003