Installation manual

4. Installation Setup
Image 4-22
Scan Connectors Settings
J15 1 Red Horizontal Scan connector
J25 1 Green Horizontal Scan connector
J35 1 Blue Horizontal Scan connector
J15 2 Red Vertical Scan connector
J25 2 Green Vertical Scan connector
J35 2 Blue Vertical Scan connector
Putting back the protection
plate
1. After setting the scan connectors, put the protection plate back in place and secure it with the bolts.
The following procedure can only be done after power (mains) connection. So, first continue with the projector
setup and the connections and then return to this procedure.
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
1. Switch on the projector.
The projector starts up on the last selected source.
2. Press the ADJUST key on the RCU.
The Adjustment Mode menu will be displayed.
26
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003