Installation manual

4. Installation Setup
3. Push the ↑ or ↓ keys to highlight Service.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-1
4. Press ENTER to select.
The Service Mode menu will be displayed.
5. Push the ↑ or ↓ keys to highlight Projector Set-Up and press ENTER.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-2
The Projector Set-Up menu will be displayed.
6. Push the ↑ or ↓ keys to highlight Identification.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
ABL CONTROLLER
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-3
7. Press ENTER to select.
The identification screen will be displayed. This screen gives the current information about the projector configuration in the line
entitled Config.
All projectors leave the factory set with a ceiling/front configuration.
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003 27