Installation manual

5. AC Power
5. AC POWER
Overview
• AC Power Cord Connection
• AC Power Voltage
• Switching on the projector
5.1 AC Power Cord Connection
How to connect the AC Power Cord?
Use the supplied power cord to connect your projector to the wall outlet.
1. Plug the female power connector into the male connector at the front side of the electronic block.
POWER MAINS
COMM. PORT
REMOTE
REMOTE
IR
IR
RS 232 OUT
RS 232 OUT
RS 232 IN
RGB
Comp / H-Sync V-Sync
RGB Comp / H-Sync
DEFOCUS
DEFOCUS
75 Ohm
OFF - ON
75 Ohm
ON - OFF
75 Ohm
OFF - ON
75 Ohm
ON - OFF
red: standby
green: operation
red: standby
green: operation
X-POS Y-POS
X-POSY-POS V-Sync
RS 232 IN
COMM. PORTPORT 3
PORT 4 / 5
PORT 4 / 5
PORT 2
PORT 2
PROJECTOR MODE
PROJECTOR MODE
PORT 1
ONOFF
ONOFF
POWER MAINS
800 periphals
800 periphals
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
PORT 3 PORT 1
Image 5-1
AC Power Cord Connection
How to prepare the AC Power Cord?
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows:
• The yellow/green wire is ground and must be connected to the terminal in the plug which is marked by the letter E or colored
yellow and green.
• The blue (white) wire is neutral and must be connected to the terminal marked with the letter N or colored black.
• The brown (black) wire is the line and must be connected to the terminal marked with the letter L or colored red.
CEE 7 Plug
Green and yellow : Ground
Blue : Neutral
Brown : Line
ANSI 73.11 Plug
Green and yellow : Ground
White : Neutral
Black : Line
Image 5-2
Power cord plugs
5.2 AC Power Voltage
What is the AC Power Voltage?
The power input voltage is autoranging between 100V (-10%) and 240V (+6%).
Which Fuses are used?
Following fuses are used:
• 2x T10A (Order number R314521)
• 1x F10A (Order number R314155)
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003
29