Installation manual

5. AC Power
For continued protection against fire hazard: replace with the same type of fuse and refer replacement to
qualified service personnel.
5.3 Switching on the projector
Howtoswitchontheprojector?
1. Press the mains ON/OFF switch to switch on the projector.
Pressed
ON
Not Pressed
OFF
Table 5 - 1
Mains Power Switch
POWER MAINS
COMM. PORT
REMOTE
REMOTE
IR
IR
RS 232 OUT
RS 232 OUT
RS 232 IN
RGB
Comp / H-Sync V-Sync
RGB Comp / H-Sync
DEFOCUS
DEFOCUS
75 Ohm
OFF - ON
75 Ohm
ON - OFF
75 Ohm
OFF - ON
75 Ohm
ON - OFF
red: standby
green: operation
red: standby
green: operation
X-POS Y-POS
X-POSY-POS V-Sync
RS 232 IN
COMM. PORTPORT 3
PORT 4 / 5
PORT 4 / 5
PORT 2
PORT 2
PROJECTOR MODE
PROJECTOR MODE
PORT 1
ONOFF
ONOFF
POWER MAINS
800 periphals
800 periphals
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
PORT 3 PORT 1
Image 5-3
The Stand by indication lamp will show the status of the projector:
No light up
Switched OFF
Green color Operational mode
Red color
Stand By mode
Table 5 - 2
Status lamp
The switching on modes
When switching on with the power switch, the projector can start in 2 different modes depending on the “Power Up” setting in the
Service mode:
• Operational mode (Picture displayed).
• Stand By mode.
Starting up in Operational Mode
The projector can start up with the selected source or the projector can start up with a warm up cycle message.
PROJECTOR WARM UP
A FULL WHITE PATTERN WILL BE
GENERATED FOR x MIN.
FOR IMMEDIATE USE OF THE
PROJECTOR, PRESS <EXIT>
WARNING: SKIPPING THIS
PROCEDURE CAN REDUCE THE
INITIAL PICTURE QUALITY OF THE
PROJECTED IMAGE;
YOU CAN ADJUST THE IMAGE
DIMENSIONS WITH THE ARROW
KEYS TO AVOID SCANNING ON
THE EDGES OF THE CRT’S;
THIS OPTION CAN BE DISABLED IN
THE SERVICE MENU
with <ENTER>
<EXIT> to return
Menu 5-1
When this warm up cycle message appears on the screen, the menu offers the possibility to start with a x minutes taking warm up
period (press ENTER) or to skip this cycle (press EXIT). The x minutes and the horizontal frequency can be programmed in the
’Service mode’ under the item ’Projector Set Up’.
30
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003