Installation manual

6. Source Connections
6.2 RGB Analog Source to Port 3
Which signal to Port 3?
Connect your RGB source with sync on green, composite or separate sync via an interface to Port 3. Always use an interface (e.g.
Barco Magik Interface R9828120) when a computer and local monitor have to be connected to the projector as the signal cable
coming from the computer is limited to 60 cm due to interferences. The RGB analog input accepts only sources with a horizontal
frequency of 32 kHz and higher.
To connect a source lower than 32 kHz, an Optional Decoder + Limo Pro (R9828631) has to be installed.
Computer
Port on projector
(R9828120)
Magik Interface
to computer
to monitor
PORT 3
Image 6-2
Port 3
Pin configuration D9 connector of Port 3
Pin # Signal
1
Not Connected
2
Ground RGBS
3 Red
4
Green
5
Blue
6
Ground RGBS
7
Ground RGBS
8
Hor. / Comp. Sync.
9
Vert. Sync.
Table 6-2
Pin configuration D9 connector of Port 3
Port 3 Input Selection
1. Press digit button 3 on the RCU.
Settings on module level
In the case of this second RGB input there are three different settings:
•75Ω Termination Resistor.
• BlueinGreenSwitch.
• Force Negative Sync Switch.
34
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003