Installation manual

6. Source Connections
Image 6-8
Disconnect the mini-connector J3
Note: When an op tional Limo Plus is installed, th e mini-connector is connected to the Limo Plus Print in s lot 3.
6. Extract the second RGB module out of the main frame.
Image 6-9
Extract the module out of the main frame
7. When finished, reconnect mini-connector J3, secure the printed circuit boards and put back the protection plate.
75Ω Termination Resistors
In case of chaining (loop-through) the projectors, the 75Ω line termination resistors must be removed from the second RGB Input
Module when the projector is NOT the last unit in the chain.
In case of a stand-alone projector, do not remove the 75Ω Termination Resistors.
75Ω Resisters on module
Line Terminated
75Ω Resisters removed
Line Not Terminated
Table 6-3
75Ω Termination Resistors
How to remove the 75Ω Termination Resistors
1. Turn Off the projector and unplug the projector power cord.
2. Remove the protection plate on top of the electric block.
3. Remo
ve the RGB Input Module from the main frame.
4. Unsolder and remove the resistors.
Blue in Green Switch
Blue characters are difficult to read, therefore the blue text will be displayed as cyan so that the readability becomes better.
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003
37