Installation manual

6. Source Connections
Blue in Green Switch in the ON position Blue in Green Active
Blue in Green Switch in the OFF position Blue in Green Disabled
Table 6-4
Blue in Green Switch
Leaving the switch in the ON position will result in abnormal color balance of the projected image.
Force Negative Sync Switch
Force Negative Sync Switch in the ON position The Sync Pulses must be Negative
Force Negative Sync Switch in the OFF position The Sync Polarity will be Automatically Detected
6.3 RGB Analog Source with Composite Sync to Port 4/5
Which signal to Port 4/5?
RGB analog input terminals with separate H and V sync inputs, composite sync input or with sync on green (BNC terminals). The
projector detects automatically where the sync signal is located.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be
connected to the projector as the signal cable coming from the computer is limited to 60 cm due to interfer-
ences.
The RGB analog input accepts only sources with a horizontal frequency of 32 kHz and higher. To connect a
source lower than 32 kHz, an Optional Decoder + Limo Pro (R9828631) has to be installed.
Computer
Port on projector
(R9828120)
Magik Interface
to computer
to monitor
RGB
Comp / H-Sync V-Sync
PORT 4 / 5
Image 6-10
Port 4/5
RGB Analog Video with Composite Sync Input Selection
1. Press digit button 4 or 5 on the RCU.
Button 4 on the RCU Sync. on Green
Button 5 on the RCU Separate Sync.
Table 6 - 6
Port 4/5
6.4 Component Video Source to Port 4/5
Which signal to Port 4/5?
R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance (Y) input (BNC terminals). The projector detects
automatically where the sync signal is located.
38
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003