Installation manual

7. Installation Adjustment Mode
CRT phosphor width for the green color
11,5 cm (4.5 inch)
CRT Faceplate holder
Forbidden area
Phosphor area
Projected raster
Image 7-9
CRT Phosphor Width
How to center the raster?
1. Press the ENTER key to activate the raster on the Green CRT faceplate.
2. Look into the Green lens and shift the raster with the cursor keys until it is centered in the middle of the CRT faceplate.
PERFECT RASTER POSITION
WRONG RASTER POSITIONS
Image 7-10
Raster Positions
3. Press the ENTER key to activate the raster on the Red CRT faceplate.
4. Shift the Red raster with the cursor keys until the raster is centered on the CRT faceplate.
5. Press the ENTER key to activate the raster on the Blue CRT faceplate.
6. Shift the Blue raster with the cursor keys until the raster is centered on the CRT faceplate.
7. Press ENTER to continue with the CRT Projection Angle Adjustment.
7.7 CRT Projection Angle Adjustment
Introduction
The projection angle of the Red and Blue CRT’s is dependent on the desired size of the projected image. A new projection angle
adjustment is required whenev
er a new screenwidth SW is adopted. If the centers of green, blue and red do not coincide, the CRT
projection angle must be adjusted.
Following screen will be displayed when starting this CRT Projection Angle Adjustment:
R5976397 BARCOREALITY 909 SPLIT PACK 27/02/2003
47