Domestic Installation and Operating Instructions ® Zip Domestic Chill Tap Undersink filtered / unfiltered domestic chilled drinking water 76121 - 60 Glass/Hr Filtered UCCT12FXV Zip Domestic Chill Tap - Installation & Operating Instructions - 87403 - June 2007 Page 1 of 8
Page 2 of 8 Zip Domestic Chill Tap - Installation & Operating Instructions - 87403 - June 2007
## Section Heading Read These Warnings First Please read all installation requirements, installation procedures and precautions before installing any Zip Chill Tap. Never attempt to install any Zip Chill Tap without reading all of the applicable instructions. All electrical connections must comply with current wiring rules. This appliance is not designed for use by young children or infirm people without supervision.
# Domestic Installation Instructions continued Use a 25 mm sheet metal punch to create a neat hole without burrs. Remove the nut and washer from the base of the carafe filler, leaving the rubbersealing ring in place. Fit the carafe filler and seal to the sink, oriented so that the operating lever is away from the sink bowl. Slide the washer and nut over the tubes from under the sink, and tighten the nut to secure the carafe filler firmly into place.
## Domestic Installation Instructions continued Section Heading Take care, when bending rigid plastic tubing, to prevent it from kinking or crushing around a bend. As it is plastic tubing containing water under mains pressure, be careful not to nick, scratch or damage it during installation. Cut the tube squarely with a sharp knife or tube cutter. Shake out and remove any swarf and debris. Ensure there is adequate ventilation available through the cupboard.
# Domestic Operating Procedures Operation ROTATE Chilled water is obtained by rotating the lever on the carafe filler. The water is chilled by a refrigeration unit fitted within the cabinet stand, under the basin. With the carafe filler, you can obtain chilled water within the rated capacity, for as long as you leave the lever in the open (vertical) position. When finished, return the lever to the OFF (upright) position.
## Domestic Warranty Information Section Heading Certain warranties may be implied by law into your contract with Zip. The warranty provided below is additional to these implied warranties and nothing set out below shall limit your statutory rights or rights at law.
Contact Details Head Office Zip Heaters (Aust) Pty. Ltd. ABN 46 000 578 727 67 Allingham Street Condell Park NSW 2200 Postal: Locked Bag 80 Bankstown 1885 Australia Website: www.zipheaters.
