Owner`s manual

HS115 Automatic Metering System
To avoid unneeded service calls, prevent possible injuries, and get the most
out of your pump, READ THIS MANUAL CAREFULLY!
This manual describes how to install, setup, operate and maintain the HS115
Automatic Metering System (AMS). Material in this manual is subject to
change without notice. Manual revisions will be made on an as needed basis.
Special circumstances involving important design, operation or application
information will be released via Equipment Technical Bulletins.
Table of Contents
Safety .................................................................. 2
General Information .................................................................. 3
Specifications .................................................................. 3-4
Installation .................................................................. 4-7
Setup & Programming .................................................................. 7-9
Maintenance .................................................................. 9-11
Troubleshooting .................................................................. 11-13
Warranty .................................................................. 13
Ordering Information .................................................................. 13
Safety
These are the safety alert symbols. When you see these symbols
on your system or in this manual, look for one of the following
signal words and be alert to the potential for personal injury.
CAUTION warns you about hazards that will or can cause minor personal
injury or property damage if ignored.
The label NOTICE indicates special instructions which are important but not
related to hazards.
These symbols on the unit mean:
Direct Current
Alternating Current
2