Owner`s manual

Figure 4. HS115 Installation
Schematic View
Figure 5. Inserting D-Cell
Batteries
c. Slide the suction line tubing onto the barbed fitting of the
Heatsavr™ bottle cap, making sure the tubing is fully seated on
the barb. Secure the tubing on the barbed fitting with a zip tie
(Fig 3b).
d. *If you notice small air bubbles form in the line during pump
priming take the line off, cut off ½ inch and repeat step c.
Power Supply:
115VAC Power Cord Version
This unit comes with a standard power cord. No ground connection is
required.
230VAC Power Cord Version
This unit comes pre-wired for 230 VAC. A 15-amp branch circuit protection
(circuit breaker) must be included in the building’s electrical installation. It
must be installed in close proximity and within easy reach of the HS115
operator. The circuit breaker must be marked as the disconnecting device for
the HS115. If the equipment is used in a manner not specified by the
manufacturer the protection provided may be impaired.
D-Cell Battery Powered Version
This unit comes with a battery pack for 4 D-Cell batteries (batteries not
included). The D-Cell battery holder is housed in the battery compartment.
Installation
1. Remove the 4 screws holding the battery housing top in place (the
battery pack bezel).
2. Lift off the top and remove the battery holder, being careful not to
damage the gasket.
3. Insert 4 D-cell batteries as indicated. (Fig 5)
4. Replace the battery holder and battery housing top.
5. Refit and tighten the 4 screws, being careful not to damage the gasket.
Ensure that the front plate is firmly in place and the screws properly
tightened to prevent moisture from entering into the unit and to
maintain the HS115 water resistance.
It is not necessary to remove the front of the pump control
box. The batteries are in the battery compartment. They can
be changed without opening the pump side of the HS115.
Battery Life
It is important to know that there is significant difference in quality
between commercially available D-cell batteries. “Heavy-duty” and
“Copper Top” brand batteries tend to last the shortest length of time, while
the Duracell Ultra M3 and Energizer Max batteries can last up to ten times
longer. We recommend that you ONLY use these high-quality alkaline
batteries.
There is a 3-volt lithium battery (BR2032 or CR2032) on the main PCB
that serves as an emergency backup power supply. This battery provides
backup power to retain the clock settings during power loss. It provides
enough power to retain time and event date but will not run the pump. The
life of this battery will depend on the amount of time that power is lost
during the lifetime of the pump and the average ambient temperature.
6
Battery Pack
Bezel (Housing)
Screws
Battery Pack
DR2000MF08.1