Assembly Instructions

Insert the Leg(B) onto the Iron Bar(①) as pictured above.
Thread the Iron Bar(①) through the mounting position at the base of the Leg(b) until threading on the Iron
Bar(①) is clearly visible.
Note: The mounting position is on the bottom end of the Leg(B).
Hold and align the Leg(B), until the Leg is Square and flush with the Table corner.
Repeat this process with the three remaining Legs(B).
Position the Table Top(A) facedown on a clean, non-marring surface.
Insert Iron Bar(①) with Nut downward into mounting position at the corner of the Table and
tighten with Wrench(②) until locked into position.
Repeat the same process with the remaining three Iron Bars(①).
Fully tighten all Iron Bars.
Step 2
Step 1
3 OF 6