(B1&B2) ASSEMBLY INSTRUCTIONS ASSEMBLY TIPS: 1.Remove hardware from box and sort by size. ‘Warning! immediately. 2.Please check to sec that all hardware and parts are present prior to start of assembly. 3.Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly, 1.Don't attempt to repair or modify parts that are broken of defective. Please contact the store 2.This product is for home use only and not intended for commercial establishment.
(B1&B2) ASSEMBLY INSTRUCTIONS (BOOMBOX 1 STEP 1 1.1) Place headboard downward on soft surface, 1.2) Align & place left (B) & right (C) headboard leg onto the appointed position following the marking as per diagram shown. **BACK VIEW IF PURCHASE HEADBOARD ONLY, SKIP BELOW STEPS STEP 2 Align and fasten left (B) & right (C) headboard leg to headboard panel (A) using bolt (1), lock washer (2) ,and tighten with Allen wrench (3). **BACK VIEW BOX 1 & BOX 2 STEP Allen wrench (6).
(B1&B2) ASSEMBLY INSTRUCTIONS STEP 4 Loosen the bolts from metal plate on headboard (HB) & foot board (I) to leave a gap of Smm. Align & hook bed rail (F) onto the bolts & tighten all the bolts with big Allen wrench (7). STEP 5 5.1) Align and fasten bed slat support with leveler (E) to bed slat (D) using bolts (5) and tighten with small Allen wrench (6). 5.2) Adjust leveler to touch the floor. STEP 6 Align and fasten bed slat (D) to bed rail (F) using screw (4) and tighten with screw driver (Not included).