Installation Instructions

NOTE: Once ground wires are connected, carefully tuck all wires and marrettes
into
the metal outlet box making sure that the wires are clear of the
hemisphere and downrod when positioned in mounting bracket.
Pg. #8
ELECTRICAL HOOK-UP
4
4
.
.
Make the following wire connections to the receiver unit (see fig. 6) using the
wire nuts supplied.
- connect GREEN fan wire to BARE
(ground) wire.
- connect BLACK receiver unit wire to BLACK supply wire.
- connect WHITE receiver unit wire to WHITE supply wire.
- connect WHITE receiver unit wire (MOTOR N) to WHITE fan wire.
- connect BLACK receiver unit wire (MOTOR L) to BLACK fan wire.
- connect BLUE receiver unit wire (FOR LIGHT) to BLUE light wire.
B
120 V
SUPPLY CIRCUIT
Fig. 6
Fan
In Quebec, the installation of this product must
be carried out by a qualified electrician.
Pg. #5
- After making the wire connections, ensure the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
- Ensure the splices after being made should be turned upward and
pushed carefully up into the outlet box.
Fig.2d
Fibre Washer
Metal Washer
Blade
Bracket Screw
Blade
Blade Bracket
Screw
Screw
Fig.2c
Fig.2e
INST
INST
ALLA
ALLA
TION
TION
NOTE:
All set screws must be checked and
retightened where necessary, before and after
installation.
1
1
.
.
ATTACH THE FAN BLADES
- Remove the small cover
on the top housing.
- Attach the blades to the
fan motor assembly using
the screws, metal washer
and fibre washer. Slightly
turn the blade after
installation and repeat the
same step for the other
blades.
- Re-attach the small cover
to the top housing.