Installation & Assembly

1. Remove switch housing screws and then remove bottom cap of switch housing
shell on fan.
2. Locate two wires in the switch housing (white and blue labeled “for light”).
Connect them to the light kit wire connectors.
White to white
Blue to blue
Secure those wires with wire nuts in the fan.
3. Carefully push all wires back into the switch housing. Then attach housing cover
plate to switch housing with the 3 screws provided.
4. Install light bulbs to the lampholder.
5. Attach the glass shades to the light kit, and screw up the finial. Do not
over-tighten the finial, glass may break . Slide the bowl glass over the threaded
nipple, followed by the cap, and then finial. Twist finial clockwise until snug (see
figure).
6. Lower chains thru hole in bowl and glass cap.
7. Attach chain extension.
8. Restore power and your light kit is ready for operation.
9. If the light kit does not work, turn off the electricity and lower the canopy on your
ceiling fan. Make sure the blue wire is connected to black
household wires
(please refer to electrical connections section in this manual).
INSTALLING DISC BOWL LIGHT KIT(OPTIONAL)
Page 12
WARNING:
All suspended fan (not hugger) with 190W light limiter. If the total wattage of the light bulb(s)
is more than 190W, the light is OFF until the total wattage reduce to below 190W.